A compact, low-cost atmospheric pressure, chemical ionization mass spectrometer ("mini-CIMS") has been developed for continuous underway shipboard measurements of dimethylsulfide (DMS) in seawater. The instrument was used to analyze DMS in air equilibrated with flowing seawater across a porous Teflon membrane equilibrator. The equilibrated gas stream was diluted with air containing an isotopically-labeled internal standard. DMS is ionized at atmospheric pressure via proton transfer from water vapor, then declustered, mass filtered via quadrupole mass spectrometry, and detected with an electron multiplier. The instrument described here is based on a low-cost residual gas analyzer (Stanford Research Systems), which has been modified for use as a chemical ionization mass spectrometer. The mini-CIMS has a gas phase detection limit of 220 ppt DMS for a 1 min averaging time, which is roughly equivalent to a seawater DMS concentration of 0.1 nM DMS at 20°C. The mini-CIMS has the sensitivity, selectivity, and time response required for underway measurements of surface ocean DMS over the full range of oceanographic conditions. The simple, robust design and relatively low cost of the instrument are intended to facilitate use in process studies and surveys, with potential for long-term deployment on research vessels, ships of opportunity, and large buoys.

Cl atoms in the marine atmosphere may significantly impact the lifetimes of methane and other hydrocarbons. However, the existing estimates of Cl atom levels in marine air are based on indirect evidence. Here we present measurements of the Cl precursors HOCl and Cl₂ in the marine boundary layer during June of 2009 at the Cape Verde Atmospheric Observatory in the eastern tropical Atlantic. These are the first measurements of tropospheric HOCl. HOCl and Cl₂ levels were low in air with open ocean back trajectories, with maximum levels always below 60 and 10 ppt (pmol/mol), respectively. In air with trajectories originating over Europe, HOCl and Cl₂ levels were higher, with HOCl maxima exceeding 100 ppt each day and Cl₂ reaching up to 35 ppt. The increased Cl cycling associated with long distance pollutant transport over the oceans likely impacts a wide geographic area and represents a mechanism by which human activities have increased the reactivity of the marine atmosphere. Data-constrained model simulations indicate that Cl atoms account for approximately 15 % of methane destruction on days when aged polluted air arrives at the site. A photochemical model does not adequately simulate the observed abundances of HOCl and Cl₂, raising the possibility of an unknown HOCl source.

This study examines atmospheric reactive chlorine chemistry at the Cape Verde Atmospheric Observatory in the eastern tropical Atlantic. During May–June, 2007, Cl₂ levels ranged from below detection (∼2 ppt) to 30 ppt. Elevated Cl₂ was associated with high HNO₃ (40 to 120 ppt) in polluted continental outflow transported in the marine boundary layer (MBL) to the site. Lower Cl₂ was observed in recently subsided air masses with multiday free tropospheric oceanic trajectories and in air containing Saharan dust. Model simulations show that the observations of elevated Cl₂ in polluted marine air are consistent with initiation of Cl chemistry by OH + HCl and subsequent heterogeneous, autocatalytic Cl cycling involving marine aerosols. Model estimates suggest that Cl atom reactions significantly impact the fates of methane and dimethylsulfide at Cape Verde and are moderately important for ozone cycling.

We report measurements of ambient amines and ammonia with a fast response chemical ionization mass spectrometer (CIMS) in a southeastern US forest and a moderately polluted midwestern site during the summer. At the forest site, mostly C3-amines (from pptv to tens of pptv) and ammonia (up to 2 ppbv) were detected, and they both showed temperature dependencies. Aerosol-phase amines measured thermal-desorption chemical ionization mass spectrometer (TDCIMS) showed a higher mass fraction in the evening with cooler temperatures and lower in the afternoon with warmer temperatures, a trend opposite to the gas-phase amines. Concentrations of aerosol-phase primary amines measured with Fourier transform infrared spectroscopy (FTIR) from micron and submicron particles were 2 orders of magnitude higher than the gas-phase amines. These results indicate that gas to particle conversion is one of the major processes that control the ambient amine concentrations at this forest site. Temperature dependencies of C3-amines and ammonia also imply reversible processes of evaporation of these nitrogen-containing compounds from soil surfaces in daytime and deposition to soil surfaces at nighttime. During the transported biomass burning plume events, various amines (C1-C6) appeared at the pptv level, indicating that biomass burning is a substantial source of amines in the southeastern US. At the moderately polluted Kent site, there were higher concentrations of C1- to C6-amines (pptv to tens of pptv) and ammonia (up to 6 ppbv). C1- to C3-amines and ammonia were well correlated with the ambient temperature. C4- to C6-amines showed frequent spikes during the nighttime, suggesting that they were emitted from local sources. These abundant amines and ammonia may in part explain the frequent new particle formation events reported from Kent. Higher amine concentrations measured at the polluted site than at the rural forested site highlight the importance of constraining anthropogenic emission sources of amines.