Here you'll find information that you can use to make the most effective irrigation decisions for using the water you have in your prune orchard. Included is a wide range of water supply availabilities, from no shortage to severe shortages.

An almond stockpile heated and ambient air dryer (SHAD) without an air distributor, did not adequately distribute air throughout the stockpile. Therefore, this project evaluated the effect of adding an air distributor within the SHAD A-frame as an alternative method to conventional windrow drying. Three stockpile drying tests were performed using ‘Nonpareil’, ‘Winter’, and ‘Monterey’ almond varieties with different initial (fresh) weights and kernel dry-basis moisture contents (MC) equal to 4763 kg and 11.8%, 2585 kg, and 11.5%, and 6849 kg and 21.5%, respectively. All tests were directly compared to conventional windrow drying. Almond quality parameters, including kernel MC, color, lipid oxidative stability, peroxide value, free fatty acid content, internal cavities, and insect injury were measured before and after drying. The SHAD with the air distributor properly maintained almond quality, while uniformly dehydrating almonds to the desired MC of ≤6 % within 7 days. Conventional windrow drying took up to 13.6 days, and the desired final MC was only achieved with the ‘Monterey’ variety. Thus, the SHAD fitted with a well-designed air distributor can be used to dehydrate almonds in a stockpile as an alternative to conventional windrow drying.

Dust generated by farming activities is a safety hazard to farmworkers and an environmental contaminant. During the almond (Prunus dulcis) harvest in California, dust is primarily generated by the mechanized movement of almonds disturbing the bare soil of the orchard floor, during the sun-drying, windrowing process, and as they are transferred into trucks for transport to processing facilities. Off-ground dust-less harvesting will only be achieved when the almond industry adopts feasible mechanical drying methods. Therefore, a stockpile heated and ambient air dryer (SHAD) was developed to determine the feasibility of dehydrating almonds (Var. ‘Monterey’). A stockpile containing 4,155 kg of almonds was created and almonds were dehydrated from their initial 12.6% almond kernel dry-basis moisture content (MCdb) to final MCdb of 6.04%. Drying was achieved as a combination of heated air at a temperature of 55°C in the drying plenum with airflow of 0.078 m3/s per m3 of fresh almonds. After drying, almond quality parameters were measured, including damage by molds or decay, insect injury, and presence of internal cavities. Drying energy consumption, cost, and performance indicators were also determined. The differences in MCdb between the bottom, middle, and top layers of the almond stockpile were significant (p ≤ 0.05). Post-hoc Tuckey test was conducted which indicated that the MCdb in the top layer was significantly lower than almond MCdb in the middle and bottom layers. Results showed that damage by molds or decay, insect injury, and internal cavities were 1.81%, 0%, and 1.77%, respectively, after drying. Therefore, the overall almond quality was not compromised. The drying process cost $11.65 per tonne of the initial weight of almonds with a Specific Moisture Extraction Rate (SMER) of 0.64 kg/kWh, Moisture Extraction Rate (MER) of 1.02 kg/h, and a Coefficient of Performance (COP) of 1.33. Comparison with other dryers in the literature shows that SMER and MER were within limits. However, a low COP was observed.

Groundwater pumping chronically exceeds natural recharge in many agricultural regions in California. A common method of recharging groundwater — when surface water is available — is to deliberately flood an open area, allowing water to percolate into an aquifer. However, open land suitable for this type of recharge is scarce. Flooding agricultural land during fallow or dormant periods has the potential to increase groundwater recharge substantially, but this approach has not been well studied. Using data on soils, topography and crop type, we developed a spatially explicit index of the suitability for groundwater recharge of land in all agricultural regions in California. We identified 3.6 million acres of agricultural land statewide as having Excellent or Good potential for groundwater recharge. The index provides preliminary guidance about the locations where groundwater recharge on agricultural land is likely to be feasible. A variety of institutional, infrastructure and other issues must also be addressed before this practice can be implemented widely.

We sequenced and comprehensively analysed the genomic architecture of 98 fluorescent pseudomonads isolated from different symptomatic and asymptomatic tissues of almond and a few other Prunus spp. Phylogenomic analyses, genome mining, field pathogenicity tests, and in vitro ice nucleation and antibiotic sensitivity tests were integrated to improve knowledge of the biology and management of bacterial blast and bacterial canker of almond. We identified Pseudomonas syringae pv. syringae, P. cerasi, and P. viridiflava as almond canker pathogens. P. syringae pv. syringae caused both canker and foliar (blast) symptoms. In contrast, P. cerasi and P. viridiflava only caused cankers, and P. viridiflava appeared to be a weak pathogen of almond. Isolates belonging to P. syringae pv. syringae were the most frequently isolated among the pathogenic species/pathovars, composing 75% of all pathogenic isolates. P. cerasi and P. viridiflava isolates composed 8.3 and 16.7% of the pathogenic isolates, respectively. Laboratory leaf infiltration bioassays produced results distinct from experiments in the field with both P. cerasi and P. syringae pv. syringae, causing significant necrosis and browning of detached leaves, whereas P. viridiflava conferred moderate effects. Genome mining revealed the absence of key epiphytic fitness-related genes in P. cerasi and P. viridiflava genomic sequences, which could explain the contrasting field and laboratory bioassay results. P. syringae pv. syringae and P. cerasi isolates harboured the ice nucleation protein, which correlated with the ice nucleation phenotype. Results of sensitivity tests to copper and kasugamycin showed a strong linkage to putative resistance genes. Isolates harbouring the ctpV gene showed resistance to copper up to 600 μg/ml. In contrast, isolates without the ctpV gene could not grow on nutrient agar amended with 200 μg/ml copper, suggesting ctpV can be used to phenotype copper resistance. All isolates were sensitive to kasugamycin at the label-recommended rate of 100μg/ml.