The aim of this project was to evaluate and characterize the performance of a MOLEKULE AIR air cleaner unit. The testing protocol comprised the evaluation of an unused Molekule Air unit operating at maximum (“boost” setting) fan speed setting. The device was tested over initial short-term periods of 70-80 h of continuous operation. The tested air cleaner was challenged in separate experiments with a well-characterized mixture of volatile organic compounds (VOCs), and with ozone. All tests were performed at realistic pollutant levels in a 20-m3 environmental stainless-steel chamber. Variables controlled and measured in this study included the chamber temperature, relative humidity, the composition and concentration of the challenge VOCs, and the concentrations of ozone. Potential formation of byproducts was also investigated to assess the overall performance.

The presence of toxic metals in tobacco smoke is well documented. However, few studies have quantified trace metals in secondhand smoke (SHS) and thirdhand smoke (THS). Their presence in indoor air can contribute to nonsmokers’ exposures and health effects. In this study, emission and deposition rates of toxic trace metals were determined, and their airborne concentration in typical indoor scenarios was predicted. PM2.5 was collected on Teflon-coated filters at various times following a smoking event in a room-sized chamber over a 43 h period. The concentration of 28 trace metals was determined by extraction and analysis using inductively coupled plasma-triple quadrupole-mass spectrometry (ICP-QQQ-MS). Emission and indoor deposition rates of cadmium, arsenic, chromium, manganese, beryllium and selenium were determined, and used to predict concentrations expected in a smokers’ home and a smoking bar. In most of the considered scenarios, average indoor concentrations of Cd, As, and Cr exceeded their corresponding cancer risk thresholds and, in some cases, also noncancer reference exposure levels, more than 3 h after smoking ended. The fraction of cadmium that remained airborne was significantly higher than those of other metal traces and that of PM2.5, suggesting an association of Cd traces with small particles.

A new generation of electronic cigarettes is exacerbating the youth vaping epidemic by incorporating additives that increase the acidity of generated aerosols, which facilitate uptake of high nicotine levels. We need to better understand the chemical speciation of vaping aerosols to assess the impact of acidification. Here we used X-ray photoelectron spectroscopy (XPS) and near-edge X-ray absorption fine structure (NEXAFS) spectroscopy to probe the acid-base equilibria of nicotine in hydrated vaping aerosols. We show that, unlike the behavior observed in bulk water, nicotine in the core of aqueous particles was partially protonated when the pH of the nebulized solution was 10.4, with a fraction of free-base nicotine (α_FB) of 0.34. Nicotine was further protonated by acidification with equimolar addition of benzoic acid (α_FB = 0.17 at pH 6.2). By contrast, the degree of nicotine protonation at the particle surface was significantly lower, with 0.72 < α_FB < 0.80 in the same pH range. The presence of propylene glycol and glycerol completely eliminated protonation of nicotine at the surface (α_FB = 1) while not affecting significantly its acid-base equilibrium in the particle core. These results provide a better understanding of the role of acidifying additives in vaping aerosols, supporting public health policy interventions.

Volatile organic chemicals are produced from reactions of ozone with squalene in human skin oil. Both primary and secondary reaction products, i.e., 6-methyl-5-hepten-2-one (6-MHO) and 4-oxopentanal (4-OPA), have been reported in indoor occupied spaces. However, the abundance of these products indoors is a function of many variables, including the amount of ozone and occupants present as well as indoor removal processes. In this study, we develop a time-dependent kinetic model describing the behavior of ozone/squalene reaction products indoors, including the reaction process and physical adsorption process of products on indoor surfaces. The key parameters in the model were obtained by fitting time-resolved concentrations of 6-MHO, 4-OPA, and ozone in a university classroom on 1 day with multiple class sessions. The model predictions were subsequently tested against observations from four additional measurement days in the same classroom. Model predictions and experimental data agreed well (R² = 0.87-0.92) for all test days, including ∼7 class sessions covering a range of occupants (10-70) and ozone concentrations (0.09-32 ppb), demonstrating the effectiveness of the model. Accounting for surface uptake of 6-MHO and 4-OPA significantly improved model predictions (R² = 0.52-0.76 without surface uptake), reflecting the importance of including surface interactions to quantitatively represent product behavior in indoor environments.

Research on the sources of indoor airborne chemicals has traditionally focused on outdoor air, building materials, furnishings, and activities such as smoking, cooking, and cleaning. Relatively little research has examined the direct role of occupant emissions, even though this source clearly contributes to indoor volatile organic compounds (VOCs) and influences indoor chemistry. In this work, we quantify occupant-related gaseous VOC emissions in a university classroom using a proton-transfer-reaction time-of-flight mass spectrometer. Time-resolved concentrations of VOCs in room air and supply air were measured continuously during occupied and unoccupied periods. The emission factor for each human-emitted VOC was determined by dividing the occupant-associated source rate by the corresponding occupancy. Among the most abundant species detected were compounds associated with personal care products. Also prominent were human metabolic emissions, such as isoprene, methanol, acetone, and acetic acid. Additional sources included human skin oil oxidation by ozone, producing compounds such as 4-oxopentanal (4-OPA) and 6-methyl-5-hepten-2-one (6-MHO). By mass, human-emitted VOCs were the dominant source (57%) during occupied periods in a well-ventilated classroom, with ventilation supply air the second most important (35%), and indoor nonoccupant emissions the least (8%). The total occupant-associated VOC emission factor was 6.3 mg h^-1 per person.

Direct human emissions are known to contribute volatile organic compounds (VOCs) to indoor air via various mechanisms. However, few measurements that determine the emissions of a full suite of occupant-associated VOCs are available. We measured occupant-related VOC emissions from engineering students in a classroom using a proton-transfer-reaction time-of-flight mass spectrometer (PTR-TOF-MS). The dominant compound emitted was a cyclic volatile methylsiloxane (cVMS), decamethylcyclopentasiloxane (D5), which is a major inactive ingredient in some personal care products such as antiperspirants. D5 was found to contribute ∼30% of the total indoor VOC mass concentration as measured by the PTR-TOF-MS. Octamethylcyclotetrasiloxane (D4) and dodecamethylcyclohexasiloxane (D6) were detected at abundances that were 1-2 orders of magnitude lower. The per-person emission rate of these three cVMS declined monotonically from morning into the afternoon, consistent with expectations for emissions from daily morning application of personal care products.

Indoor air cleaning systems that incorporate CO₂ sorbent materials enable HVAC load shifting and efficiency improvements. This study developed a bench-scale experimental system to evaluate the performance of a sorbent under controlled operation conditions. A thermostatic holder containing 3.15 g sorbent was connected to a manifold that delivered CO₂ -enriched air at a known temperature and relative humidity (RH). The air stream was also enriched with 0.8-2.1 ppm formaldehyde. The CO₂ concentration was monitored in real-time upstream and downstream of the sorbent, and integrated formaldehyde samples were collected at different times using DNPH-coated silica cartridges. Sorbent regeneration was carried out by circulating clean air in countercurrent. Almost 200 loading/regeneration cycles were performed in the span of 17 months, from which 104 were carried out at reference test conditions defined by loading with air at 25°C, 38% RH, and 1000 ppm CO₂ , and regenerating with air at 80°C, 3% RH and 400 ppm CO₂ . The working capacity decreased slightly from 43-44 mg CO₂ per g sorbent to 39-40 mg per g over the 17 months. The capacity increased with lower loading temperature (in the range 15-35°C) and higher regeneration temperature, between 40 and 80°C. The CO₂ capacity was not sensitive to the moisture content in the range 6-9 g/m³ , and decreased slightly when dry air was used. Loading isothermal breakthrough curves were fitted to three simple adsorption models, verifying that pseudo-first-order kinetics appropriately describes the adsorption process. The model predicted that equilibrium capacities decreased with increasing temperature from 15 to 35°C, while adsorption rate constants slightly increased. The formaldehyde adsorption efficiency was 80%-99% in different cycles, corresponding to an average capacity of 86 ± 36 µg/g. Formaldehyde was not quantitatively released during regeneration, but its accumulation on the sorbent did not affect CO₂ adsorption.

Ozonation is a common remediation approach to eliminate odors from mold, tobacco and fire damage in buildings. Little information exists to: 1) assess its effectiveness; 2) provide guidance on operation conditions; and 3) identify potential risks associated with the presence of indoor ozone and ozonation byproducts. The goal of this study is to evaluate chemical changes in thirdhand smoke (THS) aerosols induced by high levels of ozone, in comparison with THS aerosols aged under similar conditions in the absence of ozone. Samples representing different stages of smoke aging in the absence of ozone, including freshly emitted secondhand smoke (SHS) and THS, were collected inside an 18-m³ room-sized chamber over a period of 42 h after six cigarettes were consumed. The experiments involved collection and analysis of gas phase species including volatile organic compounds (VOCs), volatile carbonyls, semivolatile organic compounds (SVOCs), and particulate matter. VOC analysis was carried out by gas chromatography/mass spectrometry with a thermal desorption inlet (TD-GC/MS), and volatile carbonyls were analyzed by on-line derivatization with dinitrophenylhydrazine (DNPH), followed by liquid chromatography with UV/VIS detection. SVOCs were extracted from XAD-coated denuders and Teflon-coated fiberglass filters in the absence of ozone. In those extracts, tobacco-specific nitrosamines (TSNAs) and other SVOCs were analyzed by gas chromatography with positive chemical ionization-triple quadrupole mass spectrometric detection (GC/PCI-QQQ-MS), and polycyclic aromatic hydrocarbons (PAHs) were quantified by gas chromatography with ion trap mass spectrometric detection (GC/IT-MS) in selected ion monitoring mode. Particulate matter concentration was determined gravimetrically. In a second experiment, a 300 mg h^-1 commercial ozone generator was operated during 1 h, one day after smoke was generated, to evaluate the remediation of THS by ozonation. VOCs and volatile carbonyls were analyzed before and after ozonation. Extracts from fabrics that were exposed in the chamber before and after ozonation as surrogates for indoor furnishings were analyzed by GC/IT-MS, and aerosol size distribution was studied with a scanning mobility particle sizer. Ozone concentration was measured with a photometric detector. An estimated 175 mg ozone reacted with THS after 1 h of treatment, corresponding to 58% of the total O₃ released during that period. Fabric-bound nicotine was depleted after ozonation, and the surface concentration of PAHs adsorbed to fabric specimens decreased by an order of magnitude due to reaction with ozone, reaching pre-smoking levels. These results suggest that ozonation has the potential to remove harmful THS chemicals from indoor surfaces. However, gas phase concentrations of volatile carbonyls, including formaldehyde, acetaldehyde and acetone were higher immediately after ozonation. Ultrafine particles (UFP, in most cases with size <60 nm) were a major ozonation byproduct. UFP number concentrations peaked shortly after ozonation ended, and remained at higher-than background levels for several hours. Based on these results, minimum re-entry times after ozone treatment were predicted for different indoor scenarios. Clearly defining re-entry times can serve as a practical measure to prevent acute exposures to ozone and harmful ozonation byproducts after treatment. This study evaluated potential benefits and risks associated with THS remediation using ozone, providing insights into this technology.

Infants in neonatal intensive care units (NICUs) are vulnerable to environmental stressors. Few studies have reported on airborne particles in the NICU environment. During a four-day pilot study in a private-style NICU, we measured size-resolved particle number (PN) concentrations with 1-min resolution. The investigation included simultaneous sampling in an unoccupied baby room and in an incubator of an otherwise normally functioning NICU. Background submicron (0.3-1 µm) particle levels in the room were 3-4 orders of magnitude lower than outdoors, owing to high-efficiency particulate filtration of supply air. Airborne supermicron particles were detected in the room; their presence was attributed primarily to emissions from occupant movements. The fraction of in-room PN detected within an infant incubator ranged from 0.2 for particles >10 µm to 0.6 for particles with diameter 0.3-0.5 µm. The incubator humidifier was a strong additional source of particles smaller than 5 µm. Activities by researchers, designed to simulate caregiver visits, were associated with elevated particle concentrations across all measured size ranges, and were particularly discernible among larger particles. Concentrations increased with the number of occupants and with the duration and vigor of activities. The highest levels were observed when fabrics were handled. Against the low background in this environment, even small occupancy-associated perturbations – such as from a brief entry – were discernible. Measurements from a second NICU in a different US region were found to be broadly similar. A notable difference was higher submicron particle levels in the second NICU, attributed to elevated outdoor pollution.