Skip to main content
eScholarship
Open Access Publications from the University of California

3-D Mechanical Analysis of the ECR Source Magnet for FRIB

  • Author(s): Rochepault, E
  • Felice, H
  • Hafalia, R
  • Caspi, S
  • Prestemon, S
  • Pozdeyev, E
  • Machicoane, G
  • et al.

Published Web Location

http://10.0.4.85/tasc.2014.2374420
No data is associated with this publication.
Abstract

© 2002-2011 IEEE. The ECR source magnet of the FRIB facility has been designed by the Superconducting Magnet Program at the Lawrence Berkeley National Laboratory (LBNL). The magnetic parameters are close to the VENUS magnet (sextupole-in-solenoids) operated at LBNL. The mechanical assembly concept, however, is different and uses a shell-based support structure. The main advantage of this structure is the ability to finely tune the sextupole prestress both azimuthally (by way of bladder and key technology, and axially by means of end plates. This method of structural pre-loading applies the desired compression on the sextupole coils while maintaining acceptable peak stresses. Also, bladder and key technology is a reversible assembly process allowing fast and easy coil replacement, when necessary. This paper also describes the mechanical analysis required to estimate the sextupole and solenoids preloads. The stress distribution in the windings and structural components are presented during assembly, cool-down, and magnet excitation.

Item not freely available? Link broken?
Report a problem accessing this item