Knowledge and control of surface charge or potential is important for tailoring colloidal interactions. In this work, we compare widely used zeta potential (ζ) measurements of charged lipid vesicle surface potential to direct measurements using the surface force apparatus (SFA). Our measurements show good agreement between the two techniques. On varying the fraction of anionic lipids dimyristoylphosphatidylserine (DMPS) or dimyristoylphosphatidylglycerol (DMPG) mixed with zwitterionic dimyristoylphosphatidylcholine (DMPC) from 0 to 100 mol % we observed a near-linear increase in membrane surface charge or potential up to 20-30 mol % charged lipids beyond which charge saturation occurred in physiological (high) salt conditions. Similarly, in low salt concentrations, a linear increase in charge/potential was found but only up to ∼5-10 mol % charged lipids beyond which the surface charge or potential leveled off. While a lower degree of ionization is expected due to the lower dielectric constant (ε ∼ 4) of the lipid acyl chain environment, increasing intramembrane electrostatic repulsion between neighboring charged lipid head groups at higher charge loading contributes to charge suppression. Measured potentials in physiological salt solutions were consistent with predictions using the Gouy-Chapman-Stern-Grahame (GCSG) model of the electrical double layer with Langmuir binding of counterions, but in low salt conditions, the model significantly overestimated the surface charge/potential. The much lower ionization in low salt (maximum ∼1-2% of total lipids ionized) instead was consistent with counterion condensation at the bilayer surface which limited the charge that could be obtained. The strong interplay between membrane composition, lipid headgroup ionization, electrolyte concentration, and solution pH complicates exact prediction and tuning of membrane surface charge for applications. However, the theoretical frameworks used here can provide guidelines to understand this interplay and establish a range of achievable potentials for a system and predict the response to triggers like pH and salt concentration changes.

For serial femtosecond crystallography at X-ray free-electron lasers, which entails collection of single-pulse diffraction patterns from a constantly refreshed supply of microcrystalline sample, delivery of the sample into the X-ray beam path while maintaining low background remains a technical challenge for some experiments, especially where this methodology is applied to relatively low-ordered samples or those difficult to purify and crystallize in large quantities. This work demonstrates a scheme to encapsulate biological samples using polymer thin films and graphene to maintain sample hydration in vacuum conditions. The encapsulated sample is delivered into the X-ray beam on fixed targets for rapid scanning using the Roadrunner fixed-target system towards a long-term goal of low-background measurements on weakly diffracting samples. As a proof of principle, we used microcrystals of the 24 kDa rapid encystment protein (REP24) to provide a benchmark for polymer/graphene sandwich performance. The REP24 microcrystal unit cell obtained from our sandwiched in-vacuum sample was consistent with previously established unit-cell parameters and with those measured by us without encapsulation in humidified helium, indicating that the platform is robust against evaporative losses. While significant scattering from water was observed because of the sample-deposition method, the polymer/graphene sandwich itself was shown to contribute minimally to background scattering.