Electromechanical reshaping (EMR) of cartilage has been suggested as an alternative to the classical surgical techniques of modifying the shape of facial cartilages. The method is based on exposure of mechanically deformed cartilaginous tissue to a low level electric field. Electro-chemical reactions within the tissue lead to reduction of internal stress, and establishment of a new equilibrium shape. The same reactions offset the electric charge balance between collagen and proteoglycan matrix and interstitial fluid responsible for maintenance of cartilage mechanical properties. The objective of this study was to investigate correlation between the electric charge transferred during EMR and equilibrium elastic modulus. We used a finite element model based on the triphasic theory of cartilage mechanical properties to study how electric charges transferred in the electro-chemical reactions in cartilage can change its mechanical responses to step displacements in unconfined compression. The concentrations of the ions, the strain field and the fluid and ion velocities within the specimen subject to an applied mechanical deformation were estimated and apparent elastic modulus (the ratio of the equilibrium axial stress to the axial strain) was calculated as a function of transferred charge. The results from numerical calculations showed that the apparent elastic modulus decreases with increase in electric charge transfer. To compare numerical model with experimental observation we measured elastic modulus of cartilage as a function of electric charge transferred in electric circuit during EMR. Good correlation between experimental and theoretical data suggests that electric charge disbalance is responsible for alteration of cartilage mechanical properties. © 2011 SPIE.

Electromechanical reshaping (EMR) of cartilage is a novel technique that has significant potential for use in facial reconstructive surgery. EMR achieves permanent shape change by initiating electrochemical redox reactions in the vicinity of stress concentrations, thereby altering mechanical properties of tissue matrix. This study reports the use of a six electrode needle-based geometric configuration to reshape cartilage. Rectangular samples (24 × 12 × 1 mm) of rabbit nasal septal cartilages were bent at a right angle in a precision-machined reshaping jig. Two parallel arrays of three platinum needle electrodes were each inserted into cartilage along the bend at 3 mm from the bend line. One array served as an anode and the other as cathode. Constant voltage at 1, 2, 4, 6, and 8 volts was applied to the arrays for 2 minutes. The specimens were then removed from the jig and rehydrated for 15 minutes in phosphate buffered saline. Following rehydration, bend angles and thicknesses were measured. Bend angle increased with increasing voltage and application time. No statistically significant bending was observed below 6 volts for 2 minutes application time. Maximum bend angle of 33 ± 8 degrees or reshaping degree of 33% was observed at 8 volts applied for 2 minutes. Current flow was small (< 0.1 A) for each case. Sample thickness was 0.9 ± 0.2 mm. ANOVA analysis showed that cartilage thickness had no significant impact on the extent of reshaping at given voltage and application time. The six needle electrode geometric configuration conforms to the voltage- and time-dependent trends predicted by previous EMR studies. In the future, the reshaping properties of other geometric configurations will be explored. © 2009 SPIE.