As part of the development of very high field dipole magnets for particle accelerators, the Superconducting Magnet Program at Lawrence Berkeley National Laboratory is developing block-type dipole magnets. One of the main challenges of this geometry is to provide support to the coil in the aperture while maintaining an adequate clear bore. Through finite element method analysis, strain-gauge measurements, and test results, this paper reviews the design of HD3, a 1-m-long, 43-mm-bore Nb3Sn dipole magnet, presents the findings in terms of strain gauges monitoring, and summarizes their implications. © 2002-2011 IEEE.

We report test results for the one meter long dipol HD3b, a block-Type accelerator quality Nb3Sn magnet built a LBNL with operational bore fields in the range of 13-15 T. Th magnet is an upgrade of the previously reported HD2 and HD3 versions, with several modifications implemented to improve conducto positioning, reduce cable "hard-way" bending radius, an strengthen electrical insulation between cables and coil parts The magnet exhibited long training behavior, but showed a goo "memory" of the trained state upon thermal cycling. Ramp-rat dependence of the quench current, field quality performance characteristics and protection heater studies were conducted. Quenc propagation velocity and quench locations were determined base on the voltage signals; quench localization was further improve using inductive quench antenna and acoustic emission sensors Short-And long-Term acoustic precursors to quenching wer observed.

Large-aperture, high-field, Nb3Sn quadrupoles are being developed by the U.S. LHC accelerator research program (LARP) for the High luminosity upgrade of the Large Hadron Collider (HiLumi-LHC). The first 1 m long, 120 mm aperture prototype, HQ01, was assembled with various sets of coils and tested at LBNL and CERN. Based on these results, several design modifications have been introduced to improve the performance for HQ02, the latest model. From the field quality perspective, the most relevant improvements are a cored cable for reduction of eddy current effects, and more uniform coil components and fabrication processes. This paper reports on the magnetic measurements of HQ02 during recent testing at the Vertical Magnet Test Facility at Fermilab. Results of baseline measurements performed with a new multilayer circuit board probe are compared with the earlier magnet. An analysis of probe and measurement system performance is also presented.